Gear and Electronics

How do ice fishermen keep their holes open?

How ice anglers keep holes from freezing over: skim slush often, insulate with snow or covers, block wind, fish in a heated shelter, and avoid harmful chemicals.

On this page
  1. Skim the slush often
  2. Insulate the hole: snow, covers and tip-ups
  3. Block the wind
  4. Fish inside a heated shelter
  5. Reopening a frozen hole
  6. What not to use
  7. Marking and covering holes
  8. Common misconceptions
  9. Safety

Ice fishermen keep their holes open mostly by clearing slush often, insulating the hole, and blocking the wind. Skim the hole with a scoop or skimmer before a thin layer of ice has time to thicken. Pack snow around the rim or use an insulated cover, and fish from a heated shelter when you can. Antifreeze, salt, and other chemicals are not acceptable, since they pollute the water and can be illegal.

Skim the slush often

The most effective habit is simple: clear the hole regularly. Small skims are far easier to remove than thick ones, so use a slotted ice scoop or skimmer regularly, so each skim stays small. A slotted scoop lets the water drain and leaves the slush behind.

Insulate the hole: snow, covers and tip-ups

Snow insulates, so pack some snow around the rim of the hole. It slows freezing at the edge, where a hole is most likely to close.

Foam covers and insulated covers work well for holes you are not actively fishing, or for tip-ups. Round insulated tip-ups, such as models sold as thermal or polar tip-ups, cover the hole and keep it from freezing. They also block sunlight, which can spook some fish. For the setup side, see our guide to setting up a tip-up for ice fishing.

Block the wind

Wind speeds freezing. On a cold day with wind, an open hole can skim over within minutes, and the time varies widely with temperature and wind. Block the wind with shelter walls, a windbreak, or your body. Even a simple screen or a sled turned against the wind can make a difference.

Fish inside a heated shelter

A heated shelter is the most reliable way to keep holes open. Holes stay open when the air inside the shelter is above 32°F (0°C). If you use a heater, follow the manufacturer’s instructions closely. Use a heater only with proper ventilation and a carbon monoxide detector, and never run a gas or propane auger inside a shelter.

Our ice fishing gear overview covers shelters and heaters in more detail.

Reopening a frozen hole

If a hole freezes over, you have two main options:

  • Break it open with a spud bar or an ice chisel.
  • Re-drill it with an auger.

Drilling an existing hole can dull blades or catch them, so go slowly and check the blades afterward. Electric augers with a reverse function help clear slush when you re-drill. Once the hole is open, clear the slush with an ice dipper, a ladle, or a rubber scoop. These clear slush without chipping blades or line.

Keep line in the water below the surface where you can. Ice forming on the line at the hole can snap light line.

What not to use

Do not pour antifreeze, salt, or other chemicals on the ice to keep a hole open. They pollute the water, and they may be illegal. A propane torch at the hole is not a practical or safe routine method, either.

Some anglers coat their scoop with cooking spray so slush releases more easily. This is optional and does not replace clearing the hole.

Marking and covering holes

When you leave a hole, mark it or cover it. Refrozen holes can trap a foot, and a hidden hole is a hazard for other people on the ice. Some states require you to mark holes larger than a set size, often about 12 inches, though rules vary. Check your local regulations before you go out.

Common misconceptions

  • Chemicals are a shortcut. They are not acceptable. They pollute the water and may be illegal.
  • A bigger hole freezes more slowly. It does not. It just skims over a larger area.
  • A bucket alone stops freezing. It does not fully stop freezing in subzero cold.
  • A torch is a routine fix. It is not a practical method.

Safety

Mark or cover holes when you leave. Check the ice before you walk to a hole, and carry ice picks and a spud bar. If you use a heater, use a carbon monoxide detector. Sonar cannot measure ice thickness, so test the ice yourself.

The complete guide to gear and electronics

Ice Fishing Gear and Technology: Sonar, Rods, Line and Power
Read the guide

Keep exploring

Guides from other topics

All topics →