Techniques and Species

Ice Fishing Techniques: Finding Fish at the Right Depth

How depth shifts through the ice season, typical depths for panfish, walleye, pike, lake trout and more, and how to find fish with or without a flasher.

On this page
  1. Short answer
  2. How depth changes through the ice season
  3. Typical depths by species
  4. Why oxygen and water temperature matter
  5. Finding depth without electronics
  6. Reading a flasher
  7. Structure to target
  8. Hold bait at the right height
  9. Common depth mistakes
  10. Species pages to read next
  11. Ice safety when you change spots

Short answer

Fish move with the season, the time of day and the oxygen in the water, so no single depth works all winter. Find the structure that holds fish, such as a break, a point or a hump. Then use a flasher, or a simple bobber-stop method, to find the depth where fish are. Keep your bait at or just above them.

How depth changes through the ice season

Early in the season, fish often sit shallow on weed edges and flats. In mid-winter, many move to deeper basins and structure. Late in the ice, as the days lengthen and the snow melts, many fish return to the shallows.

Snow matters too. Thick snow cuts down light, so fish may stay shallower and feed for longer in dim conditions.

Typical depths by species

Depths vary from lake to lake, so treat these ranges as starting points:

  • Bluegill: roughly 4 to 25 ft, shallower in early and late ice and deeper over basins in mid-winter.
  • Yellow perch: often 15 to 35 ft in mid-winter on soft-bottom flats, and 6 to 15 ft on weed edges early and late.
  • Crappie: often suspended about 10 to 30 ft over basins.
  • Walleye: often 15 to 35 ft on breaks, points and humps.
  • Northern pike: often 5 to 15 ft near weeds, with big fish sometimes suspended over deeper water in mid-winter.
  • Burbot: mostly 20 to 60 ft, on rocky points, humps and flats next to deep water.
  • Lake trout: often 30 to 80 ft under the ice, and sometimes deeper.
  • Kokanee: often 10 to 40 ft under the ice, whatever the total depth.

If you are new to a lake, these ranges give you a place to begin. Then let your electronics or your bobber stop tell you where the fish are.

Why oxygen and water temperature matter

Under the ice, the water near the surface sits close to 32°F (0°C). The bottom of deeper basins is often near 39°F (4°C), which is the temperature where water is densest.

Oxygen falls through the winter. It drops fastest in shallow, weedy lakes with a lot of decaying plant matter. Fish may leave low-oxygen water and sit higher in the column. That is one reason the deepest basin is not always the best spot.

Finding depth without electronics

You can find depth without a flasher. Drop your lure to the bottom, then reel up a set number of cranks and mark the line with a bobber stop. Do this at several holes across a break, and you will have a rough depth map of the area.

This method tells you depth only. It does not tell you where the fish are, so you still need to fish the spot.

Reading a flasher

A flasher shows depth and what is passing under the lure, but not which side of the hole a fish is on.

  • Cone angle: a 20-degree cone covers a circle about one-third of the water depth across. At 30 ft, that is roughly 10 ft wide. A 9-degree cone covers about half that.
  • Colour: on many Vexilar-style units, red means a strong return, orange is medium and green is weak. Check your own unit’s manual, because colour schemes vary.
  • Bottom lock or zoom: this mode spreads the bottom few feet across the dial. It helps separate fish that hold tight to the bottom, such as perch.

For how to use the flasher while you jig, see our jigging rhythm guide.

Structure to target

Fish gather at predictable places. Look for:

  • breaklines and drop-offs
  • humps and points
  • inside turns and saddles
  • weedlines
  • transitions from mud to rock

A lake contour map or GPS app lets you mark these spots before you go. Once you are on the ice, a good test is to drill a line of holes from shallow to deep across a break and see where the fish are.

Hold bait at the right height

Fish usually rise to a bait rather than drop down to one. Hold the bait at or just above the fish you see, not below them.

How far off the bottom to hold the bait depends on the species. Crappie, kokanee and lake trout often hang off the bottom. Perch, walleye and burbot mostly stay within about 2 ft of the bottom. For crappie tactics, see the best bait for ice fishing for crappie. For walleye, see the best setup for ice fishing for walleye.

Common depth mistakes

  • Assuming fish always go deepest in winter. Many stay mid-depth or on structure, and deep basins can be low in oxygen.
  • Assuming fish are always on the bottom. Crappie, kokanee and lake trout often suspend.
  • Expecting fish to drop down to your bait. Most rise to a bait.
  • Using one depth all winter. Depth changes with the season, the time of day and oxygen levels.
  • Trusting the flasher too much. It shows depth, not exactly where a fish is.

Each species behaves differently. Once you know the depth, these guides cover tactics:

For timing, see which time is best for ice fishing.

Ice safety when you change spots

Ice is often thinner over springs, inlets and current, and near structure such as reeds and docks. Before you move onto new ground, check the thickness with a spud bar or auger. Be extra careful where water moves. For minimum thickness guidance and how to check it while you travel, see our backcountry ice fishing guide.

Keep exploring

Guides from other topics

All topics →