Shelters and Ice Houses

Anchoring an Ice Fishing Shelter in Wind

How to anchor an ice fishing shelter in wind: pick the right ice anchors, set up with the back to the wind, use every point and take it down safely.

On this page
  1. Why shelters blow away
  2. Choose the right anchors
  3. Set up in wind, in order
  4. Drive the anchors
  5. Guy lines and snow
  6. Know your wind limit
  7. Common mistakes
  8. Take it down without damage
  9. Quick checklist

Use every anchor point, set the shelter up with its back to the wind, and anchor the upwind side first. Screw-in ice anchors driven into solid ice hold far better than the shelter’s weight alone.

Why shelters blow away

Hubs catch wind like kites. A shelter’s weight alone will not hold it. An unanchored shelter can slide or blow across open ice, sometimes a long way.

A shelter that drifts can drag your gear, or you, toward open water or pressure ridges. That is the real reason to anchor it properly.

Choose the right anchors

  • Screw-in ice anchors are typically 5 to 9 inches long.
  • Hubs usually have six to eight anchor points. Use all of them.
  • Solid ice only. Anchor into solid ice, not snow or slush. Snow stakes do not hold in hard ice.
  • Flip-overs need the sled or frame anchored too. Load the sled with gear first.

Carry spare anchors. They are easy to lose in snow.

Set up in wind, in order

  1. Set the shelter with its back to the wind and the door on the downwind side.
  2. Anchor the upwind side first, before you pop out all the hubs.
  3. Pop out the remaining hubs, and anchor each corner as you go.
  4. Check that every wall is tight and every anchor is seated in the ice.

Drive the anchors

You can drive anchors with a cordless drill and a hex or nut adapter, or by hand through the eyelet. Drive each one straight into solid ice. Check them again after the wind picks up.

Guy lines and snow

Guy lines set at about 45 degrees from the shelter give the best hold. Bank snow against the skirt to block drafts and add weight.

Pouring hole water on the skirt will freeze it down. If you do this on purpose, chip it free carefully when you take the shelter down.

Know your wind limit

Hubs are risky in gusts above about 20 to 25 mph. Many anglers do not set up at all in stronger wind. This limit is a judgment call, not a rule, so check the forecast before you bring a hub out.

Common mistakes

  • Using half the anchor points. This is a common cause of bent poles and torn fabric.
  • Trusting snow stakes in hard ice. They will not hold.
  • Thinking that sitting inside anchors the shelter. Occupied shelters have still been dragged.

Take it down without damage

  • Shut off any heater before you take down or adjust the shelter in wind.
  • Back the anchors out before they freeze in. A twist or a tap helps them come free, and warm water helps too.
  • Chip the skirt free carefully, instead of forcing it.

If you run a heater in the shelter, read the heating and carbon monoxide guide before you start.

Quick checklist

  • Pick anchors that match your shelter’s anchor points.
  • Set up with the back to the wind.
  • Anchor the upwind side first.
  • Use every point.
  • Bank snow and add guy lines.
  • Carry spare anchors.
  • Shut off heaters before you adjust or take down.

For shelter types suited to wind, see the ice fishing shelters guide. For insulated hubs in cold wind, see the thermal hubs guide. For the QuickFish setup order, see the Eskimo QuickFish review.

The complete guide to shelters and ice houses

Ice Fishing Shelters: From Pop-Up Hubs to the Ultimate Ice Shack
Read the guide

Keep exploring

Guides from other topics

All topics →