A DIY ice house can be a light portable shack that you drag by hand, or a heavier skid-mounted house. Choose the style first, because it sets the size, weight and framing. Then build the floor, walls and vents in that order.
Choose portable or permanent first
A portable shack is light enough to drag or tow behind a vehicle. Smaller builds around 4x6 to 4x8 ft are easier to move. Common larger sizes are 6x8, 8x10 and 8x12 ft. Many builders keep the width under about 8 ft so the house fits on a standard trailer.
A heavier house needs a tow vehicle that can handle the load, and ice that can carry it. For that reason, many anglers settle on a size they can move with the equipment they have.
Materials
- Framing: 2x3 or 2x4 lumber, or steel or aluminum tubing for a lighter build.
- Skin: exterior plywood, OSB, or aluminum or steel siding. Use exterior-grade screws.
- Insulation: 1 to 2 inches of rigid foam between the studs. Extruded polystyrene (XPS) is roughly R-5 per inch.
- Runners: treated 2x6 or 4x4 lumber, or steel, with the front ends turned up for dragging. Wheels or a trailer suit a wheelhouse-style build.
Build the floor and fishing holes
Build the floor as a plywood deck on a framed base. Cut each hole about 2 inches wider than your auger. For an 8-inch auger, that means a 10-inch opening. Use hinged or lift-out covers so you can close the holes when you are not fishing.
Plastic catch covers or cut-down 5-gallon buckets can work as drop-through sleeves. They help block drafts and keep you from tripping on the edge of the hole.
Walls, windows and the interior
Seal the seams and the gap between the floor and the skirt. Keep windows small, and paint the interior dark to cut glare when you look down the hole.
Add tow points on the front and back, a door that locks, and reflective tape on all sides. Owner markings are often required too, so see the state rules below.
Ventilation and heat
Put at least one low vent in for fresh air and one high vent for exhaust. A vented propane heater or wall furnace is the safer choice for a permanent build. Portable heaters that are designed for indoor use still need ventilation.
Install a battery carbon monoxide alarm before you use the house. Never seal the house to stay warm. The heating and carbon monoxide guide covers heater safety in detail.
Weight and ice thickness
Heavier does not mean sturdier on the ice. Extra weight pushes the ice down and limits where you can safely go. Heavy houses need thicker ice. Many guides cite 12 inches or more of clear ice for a heavy house, but confirm the figure with your local agency. The ice fishing safety guide explains how to check thickness as you go. The ice fishing shelters guide covers general ice thickness guidance.
Check state rules before you build
Many states require the owner’s name and address, or a license number, on the house. They may also require reflectors and removal by a set date each spring. Do not assume no permit is needed. Check your state’s shelter rules before you build, and again before you use the house each season.
Remove the house and any debris before the ice-out deadline.
Common mistakes
- Building too heavy. Heavy houses sink and limit where you can go.
- Skipping vents. Any combustion heater needs fresh air and an exhaust path.
- Letting wood skids freeze in place. Block the house or move it now and then so the skids do not freeze to the ice.
- Assuming no rules apply. Check the state rules first.
For a ready-built alternative, see Ice Castle fish houses. For how to hold a shack in place once it is on the ice, see the anchoring guide.